O'Sullivan 5402 High Gloss Epoxy Wet Surface Liner

If you want to know who carries O'Sullivan 5402 High Gloss Epoxy Wet Surface Liner $75.20 a gallon, you can get it atVARNI-LITE COATINGS, 21595 CURTIS STREET, HAYWARD, CA 94545

USES: Presses, bottling lines, crushers, walls, floors, tanks pads, industrial equipment, interior / exterior wine tanks - metal and concrete



COLOR:White, Gray, Wine Press Yellow, Black, Tile Red , Clear, Special tints by request.



COVERAGE:400 Square feet per gallon average.



FINISH:High gloss



DRYING TIME:Set to touch one hour. Recoat 4 to 32 hours.



FLASH POINT:80º F



THINNER:O’Sullivan 5409 Epoxy Thinner



SURFACE PREPARATION:Steel surfaces must be sandblasted to remove mill scale, and all surfaces must be chemically clean and free of grease, dirt, dust, and residual coatings. Can be self-priming or prime with 5-334 Primer surfacer. May be used on bare wood. Steel should be sandblasted and treated with vinyl wash primer or epoxy primer 5424 before applying 2 coats of 5402.



APPLICATION:Spray gun, roller, or brush.



METHOD OF APPLICATION:Component A should be mixed before adding component B. Mechanical mixing is always preferred. Mix for 5 minutes with equal volume of component B. Set aside and do not use for one hour. VERY IMPORTANT ! From this point the mixture will have a limited useable working life. (if necessary to use thinner, it must be added after the one-hour time period). Mix again for five minutes. Pot life at 70º F is 6-8 hours. 2 or 3 thin coats of 5402 should be applied with one day between coats to allow for solvent release. Allow five days curing time and wash well with warm water before using.



RESISTS:Water, acids, alkali, oils, wine and most spirits.



CAUTION:Area should be well ventilated. User should wear approved respiratory mask when spraying. This epoxy must not be applied in temperatures below 55º F. Check actual surface temperature. Do not use near open flame, sparks or other sources of ignition. FLAMMABLE MIXTURE. Keep away from children.

I use this stuff to make wooden darkroom sinks and wash out booths for screenprinting workshops since 1975 at the old Kearny Street Workshop.  It's great stuff.  Roy Anderson Paint Company used to carry this in the city.  They have since folded up and now I have to go all the way to pick it up in Hayward.  Varni-lite's phone number is  510.887.8997.  Call them a day before so that they can pull the order.21595 Curtis St

Hayward, CA 94545-1307

(510) 887-8997

Get directions

Looks like Leon is gonna use some thing like a Thompson's Water Sealer instead....too much mullah he says.  don't say I didn't warn him!

I'm blogging about this so that I will remember where to find this later.